15 DECEMBER 83
(Supersedes LO 5-3895-372-12, 5 OCTOBER 1979)
CONCRETE-MOBILE MIXER BODY M919 MODEL 8CM-24F
Reference: TM 5-3895-372-10, and -20, LO 9-2320-273-12 and FEDERAL SUPPLY
Hard time intervals and the related manhour times are
based on normal operation.
The man-hour time
specified is the time you need to do all the services
prescribed for a particular interval.
Change the hard time interval if your lubricants are
contaminated or if you are operating the equipment
longerthan-usual operating hours.
The hard time interval
may be extended during periods of low activity.
extended, adequate preservation precautions must be
Dry cleaning fluid is flammable.
Do not use near a flame
or excessive heat.
Use only with adequate ventilation.
Avoid prolonged breathing of vapors and minimize skin
Clean parts or fittings with dry cleaning solvent (SD),
Type II or equivalent.
Dry before lubricating.
arrow shafts indicate lubrication on both sides of
A dotted circle indicates a drain below.
Relubricate all items found contaminated after fording or
The lowest level of maintenance authorized to lubricate a
point is indicated by one of the following symbols as
Operator/Crew (C); and Organizational
Reporting errors and recommending improvements.
You can help improve this manual.
If you find any
mistakes, or if you know of a way to improve the
procedures, please let us know.
Mail your letter or DA
Form 2028 (Recommended Changes to Publications and
Blank Forms) direct to:
Commander, US Army Tank-
Automotive Command, ATTN:
DRSTA-MB, Warren, MI
48090. A reply will be furnished to you.
*The time specified is the time required to perform all services
at the particular interval.
CARD 1 OF 7