1355-00-130-4101

5340-14-438-1029 5340144381029 144381029 is a standoff that must have a threaded end(s) or be internally threaded its full length. for items having external threads on both ends, see stud (as modified). for items with an outside contour that is the same for the entire length, are flat on top and bottom, having internal threads its full length, and the length does not exceed twice the width across the flats or outside diameter, see nut (as modified); use maximum dimensions(s) for compliance.

3040-01-255-6662 3040012556662 012556662 is a straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. it is not designed for use in aligning by fitting into corresponding holes of another item. it may be drilled for lubricating holes. for items having an integral gear(s) or worm(s), see gearshaft (as modified). for items designed to support rotating members see axle(1), straight. for items not having the above conditions see pin, straight, headless. for items having machined ends which constitute steps see shaft(1), shouldered; axle(1), shouldered; and bolt, fluid passage.

4130-01-300-1739 4130013001739 013001739 RESERVOIR