3040-00-009-5825

5365-12-134-4100 5365121344100 121344100 is a thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. it is designed to maintain a predetermined distance between two surfaces. for round items without a hole and having a solid rectangular cross-section use disk, solid, plain. items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. for items with thickness greater than those indicated above, see spacer, plate; washer, flat and spacer, ring. when thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. see also shim stock, laminated; shim stock assortment, gasket; and bearing, washer, thrust.

4810-01-262-4911 4810012624911 012624911 is a valve having two or more ports with valve stem or pilot needle in a normally open or closed position. it is specifically designed to stop or start or change the flow of fluid by means of the magnetic action of an electric coil on a moveable core or plunger. the valve may be equipped with a manual opening or closing device. for items with three or more ports that utilize a reciprocating slide with recess areas which mate with ports in an integral or replaceable ported sleeve, see valve (1), linear, directional control. it may be inline or cartridge (manifold) design. excludes valve (1), butterfly.

5310-12-126-4367 5310121264367 121264367 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

6150-14-262-4911 6150142624911 142624911 is an item made of rigid or semirigid conductive material, usually employed in the distribution of heavy electrical current. it is cut to specific lengths and is shaped, drilled, tapped or otherwise terminated. it may be fabricated in any of various cross-sectional shapes and sizes and may include terminal lugs. it may be designed to connect two or more screw or stud terminations. excludes terminal strip, grounding.

5330-00-262-4911 5330002624911 002624911