4310-00-072-6754

5975-14-209-0484 5975142090484 142090484 CONE DE SERRAGE POU

5315-01-462-2686 5315014622686 014622686 is a cylindrically-shaped headless item, having a shank at one or both ends. it is used for aligning, fastening, or transfer of torque and/or thrust by fitting into corresponding holes of another item. it may be threaded on one end.

5310-12-148-8507 5310121488507 121488507 is a washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.

5305-01-493-4322 5305014934322 014934322 is a screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. the nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. the head is designed to be held or driven with an inserted driver. it is not designed for rotation by the thumb and fingers. a locking feature may be incorporated in the design of the head or threads.

5305-01-493-2036 5305014932036 014932036 is a screw, machine or screw, cap, socket head whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 in.) (0.025 mm) or less of a specific diameter for items (1.000 in.) (25 mm) or less in diameter. items over (1.000 in.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 in.) (0.038 mm) or less. the nominal major diameter of the threads shall be at least one thousandth (0.001 in.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the screw thread standards, fed std h28 and/or other nationally recognized standards. the head is designed to be held or driven with an inserted driver. it is not designed for rotation by the thumb and fingers. a locking feature may be incorporated in the design of the head or threads.