5999-00-009-9940

4910-14-258-8068 4910142588068 142588068 is a device for positioning on a hydraulic brake wheel cylinder to prevent the piston from leaving the cylinder during assembly or disassembly of brake.

2930-14-424-2013 2930144242013 144242013 is a power driven item specifically designed to circulate water mixed with antifreeze and the like through the block and radiator for cooling. may include items such as pulley; coupling; gear and the like. excludes pump (as modified).

3040-01-233-0807 3040012330807 012330807 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.

5815-00-604-2586 5815006042586 006042586 is an item usually marked with letter(s), numeral(s), or other character(s) designed to be attached to a key lever of a typewriter, accounting and calculating machien, office type composing machine keyboard or keyboard, data entry for the purpose of affording fingertip operation.

3040-01-229-9705 3040012299705 012299705 is a shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. it must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. the ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. it is not designed for use in aligning by fitting into corresponding holes of another item. for items used to support rotating members see axle(1), shouldered. for items not having any of the above conditions see pin, shoulder, headless. excludes shaft(1), straight; and axle(1), straight.